English
日本語
简体中文
TMX series part 2 – How DRI influences the TMX design
In long-range observation and situational awareness systems, the focus lies on observation, surveillance, and reconnaissance. To successfully accomplish these tasks,…
TMX series part 1 – 30 Years of Adimec TMX Series
In 1994, 2 years after being founded, Adimec released the TMX-6 analog camera which was a VGA resolution monochrome camera…
How the Programmable Gain Amplifier can be used to optimize Q-21 performance (part 2)
In the previous part of this blog series, we have discussed the use of analog gain and how it compares…
How to optimize the Q-21 performance using the analog gain (part 1)
It is important to understand which camera type suits your application. However, it is as important to configure the camera…
MTF of an image sensor
During the design of an optical system, the Modulation Transfer Function (MTF) of a lens is an important factor in…
How does the S-49Axx camera compare with other Adimec cameras?
EINDHOVEN, the Netherlands October 20th, 2022 — Adimec, a world leader in application-specific, leading-edge industrial camera solutions, is expanding its…
What is the relation between full well and shot noise? Part 2
Although the shot noise increases with the signal, its relative contribution reduces As discussed in the first blog in this…
What is the relation between full well and shot noise? Part 1
The Importance of Full Well Capacity At first glance, it may not be obvious how the full well capacity of…
Semiconductor Inspection and Metrology Requires the Right Camera Technology
Semiconductors are essential components that are the foundation of electronic devices. Accurate inspections are performed after each process step…
Looking for a cost-effective solution to upgrade with higher resolution cameras for electronics inspection systems?
Adimec’s S-49A70-Kx/CXP12 New High-Resolution CXP Camera The Adimec SAPPHIRE S-49A70 CoaXPress high-performance camera brings the maximum resolution of 7008 x 7000…